A Warden company - serving Fort Lauderdale, FL

Ghost Controls Gate Motor Replacement Nationwide

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Ghost Controls Gate Motor Replacement: The Fort Lauderdale Owner’s Guide

A Ghost Controls gate motor replacement in Fort Lauderdale typically runs between $485 and $820 installed, depending on which model you have and whether the arm, cable, or control board needs replacing at the same time. We stock Ghost Controls-compatible motors and parts on our trucks, and we can usually have your gate swinging again the same day you call. Most owners discover the failure the hard way: the gate groans, stalls halfway, or simply refuses to move after a rainstorm or a power flicker. Fort Lauderdale’s salt air and daily humidity shorten the life of these motors faster than the national average, and we see the same failure pattern repeat itself from Victoria Park to Rio Vista.

Technician performing electric gate repair using a multimeter on control board nationwide

Call (754) 354-9065

Before anyone touches your gate, you’ll know the price. We write it down, hand it to you, and nothing changes unless you approve it first. That’s how Cole Rafferty runs every job at Warden Gate Repair Fort Lauderdale, and it’s non-negotiable.

Which Ghost Controls Models This Applies To

We service and replace motors across the Ghost Controls line, including the most common residential units found in Fort Lauderdale neighborhoods: the AXDP, AXCP, and TSS1 series. If you have a Ghost Controls dual-gate setup, you have two motors, and we often recommend replacing both even if only one failed. A mismatched pair fights itself, and the older motor drags the new one down within months.

Here’s the compatibility gotcha most owners don’t know: Ghost Controls changed their arm mounting geometry between older and newer production runs. A motor from 2018 may not bolt cleanly onto a 2021 bracket without an adapter plate. The model label is usually on the underside of the motor housing, but salt corrosion in Fort Lauderdale can make it unreadable. When that happens, we measure the arm travel and bolt pattern to identify the right replacement. We carry OEM Ghost Controls motors as well as quality aftermarket equivalents where the spec matches exactly. For a coastal environment like Fort Lauderdale, we lean toward OEM or marine-grade sealed aftermarket units; the aftermarket budget options don’t survive the humidity and salt the same way.

Warden Gate Repair Fort Lauderdale is an independent service provider. We’re not affiliated with Ghost Controls, but we install their parts daily and know their quirks better than most factory-authorized shops.

Explore

Styles & brands we work with

Wrought iron
Wrought iron
Wood & steel frame
Wood & steel frame
Farm & ranch
Farm & ranch
Sliding driveway gates
Sliding driveway gates
LiftMaster operators
LiftMaster operators

Signs Your Ghost Controls Gate Motor Replacement Is Failing

  • The gate moves at half speed, then stops. The motor’s capacitor is degrading, which is the single most common Ghost Controls issue we see in Fort Lauderdale. Heat and humidity accelerate capacitor failure, and once it goes, the motor can’t hold enough startup torque.
  • You hear the motor running, but the gate doesn’t move. The internal gear train has stripped, or the clutch is slipping. Ghost Controls clutches are deliberately sacrificial, meant to fail before the arm bends, but once they slip, the motor is working against nothing.
  • The opener trips the GFCI breaker whenever it runs. Moisture has infiltrated the motor housing or the wiring harness. By the time a Ghost Controls motor trips the breaker in Fort Lauderdale, the internal seals have already failed and corrosion is working through the windings.
  • The gate reverses direction randomly or opens a few inches and stops. The limit switches inside the motor are going bad, or the control board is misreading the arm position. This often gets misdiagnosed as a board issue when the motor’s internal sensors are actually the culprit.
  • There’s a grinding or clicking noise during every cycle. Bearing wear, usually accelerated by sand intrusion. Fort Lauderdale driveways pick up sand and fine shell grit, and that grit finds its way into the motor’s lower bearing seal.

If you notice any of these, call us at (754) 354-9065. A motor that’s failing gradually is still cheaper to replace now than one that seizes mid-cycle and twists the gate off its hinges.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

A Ghost Controls gate motor replacement in Fort Lauderdale typically falls between $485 and $820 installed. Here’s what drives the range:

  • Motor type: single-arm units are less than dual-arm by $150 to $250.
  • OEM vs aftermarket: OEM Ghost Controls motors run 20-30% higher than a quality equivalent, but in coastal Fort Lauderdale the sealed OEM units earn their cost back in lifespan.
  • Accessory condition: if the bracket or arm is corroded, expect $60 to $140 in additional hardware.
  • Permit or code considerations: most Fort Lauderdale residential gate replacements don’t need a permit, but if your HOA requires a matching opener model, that can change the part price.

Every quote from Warden Gate Repair Fort Lauderdale is written, itemized, and agreed to before any work starts. You won’t see a surprise line item when the job is done. The replacement motor is covered by the manufacturer’s warranty, and our labor carries the 365-Day Done Right Promise: if the repair isn’t right, we return and make it right, free of charge.

DIY or Call Us?

Replacing a gate motor involves line-voltage wiring, and on a Ghost Controls unit, the arm is under tension in certain positions. If the gate is currently stuck closed with a charged capacitor, prying at the motor can release stored energy and hurt you. We don’t recommend opening the motor housing or messing with the wiring if you’re not trained for gate electronics.

What you can safely do: check the breaker, look for visible corrosion on the motor housing, and confirm the gate itself isn’t physically binding on its hinges. If the gate swings freely by hand in manual release mode but won’t move under power, that points to the motor. At that point, call (754) 354-9065 and tell us your Ghost Controls model number. We’ll bring the right part on the first trip, and the technician arriving at your door will be the same face we sent you by photo before we ever rolled a truck.

A locked gate only protects you if it actually locks. If your Ghost Controls motor is fading in Fort Lauderdale, get it handled before the gate fails open or closed at the worst possible moment.

FAQs

Need Gate Repair help in Fort Lauderdale? Licensed & insured · 30-60 min response · free estimates
Call (754) 354-9065
Local Service Coverage

Request a Free Estimate in Fort Lauderdale

Tell us what you need - Warden Gate Repair Fort Lauderdale responds fast. No obligation.

By requesting your free estimate, you confirm you have read our Privacy Policy and agree that you may be contacted through phone, text, or email concerning your request, including by the partner businesses that may perform the service.

Prefer to text? Text Now
Call Now - 24/7 Dispatch